Scheduled For Release 2019-12-31
0003576: [Feature] Orthogonally restrict dragging of geometry in Sketcher (invoked by pressing ctrl or shift or ctrl+shift)
0003374: [Feature] Sketch + Gui.SelectionEx() - - - Identify Geometry Index Outside Edit Mode
0002774: [Feature] Can not select points in sketcher properly when changing viewangle
0003181: [Feature] Allow to toggle the construction of points
0003086: [Feature] CTRL key during line operation increase the snap active area such that it is easy to match points
0003203: [Feature] More convenient arc-drawing in polyline mode
0002492: [Feature] Multiple entities overlayed
0003107: [Feature] Customize Sketcher units
0001343: [Feature] Request for additional (dynamic) detail in error messages
0001416: [Feature] Constraints creation "on the fly"
0000845: [Feature] [Sketcher] Sketcher and Transparent solids (abdullah)
0003489: [Feature] Toggle visibility of all construction geometry
0000847: [Feature] [Sketcher] Dragging + snap to grid
0001271: [Feature] Allow User to Toggle Automatic Grid Sizeing in Sketcher On and Off
0003682: [Feature] Sketch Analysis new tests (abdullah)
0003681: [Feature] Valid profile validation at sketch exit (abdullah)
0003743: [Feature] Control log output of solver (abdullah)
0003659: [Bug] Tangent constraint shows no effect in 3D view (abdullah)
0003718: [Feature] Block constraint does not work on GeomPoints (abdullah)
0003110: [Feature] Sketcher: add support of relevant constraints to B-splines (abdullah)
0003708: [Feature] Add an Offset tool to the Sketcher (abdullah)
0003668: [Feature] Implement offset curves in the sketcher (abdullah)
0003649: [Bug] Improve handling of block constraint if dimensional constraints are involved (abdullah)
0003655: [Bug] GeomAPI_ExtremaCurveCurve fails to detect intersection (upstream OCCT bug) (abdullah)
0003684: [Feature] Support for trimming arcs of hyperbola and arcs of parabola (abdullah)
0003671: [Feature] Sketcher Analysis interface improvements (abdullah)
0003667: [Bug] wrong normals of tangents of ellipses (abdullah)
0003438: [Feature] Show in Sketcher if the sketch is closed (abdullah)
0003660: [Feature] Infinite lines in Sketcher (abdullah)
0002052: [Feature] Add Chamfer Edge-Tool (abdullah)
0001436: [Feature] Sketcher: Break a Line and Add a Point onto a Line (abdullah)
0002078: [Feature] Support to apply equality constraint on angles (abdullah)
0001560: [Feature] Provide ability to fine-tune auto constraints. (abdullah)
0 of 33 issue(s) resolved. Progress (0%). View Issues